Installing the fuel tank on your Ford Escort doesn’t have to be a problem. The tank when empty is very light and requires minimum effort to hold it in place whilst you tighten the straps. The toughest half is making certain all of your lines are connected earlier than strapping it in. Remember to give your self enough room to maneuver around and preserve your instruments inside reach to make your job easier.
Fuel Tank Installation Procedures
1. Make sure the automobile is resting on a jack or jack stands. You’ll need the clearance to have the ability to maneuver beneath the vehicle.
2. Place the fuel tank on a second jack. You need the fuel tank elevated halfway as much as set up the wiring to the fuel pump.
3. Set up the wiring harness to the pigtail meeting on high of the tank. Push the clip into the pigtail till it snaps. This may prevent the wiring from slipping out.
4. Install the fuel lines. The traces are equipped with quick-connect fittings so they will lock once you push them together.
5. Install the gas inlet hose. The hose goes into the back of the fuel tank from the gas cap. The hose will tighten to the tank with an ordinary hose clamp. Tighten with a flat-head screwdriver.
6. Raise the tank straight up. You can maintain the tank in place along with your knees while you install the straps.
7. Set up the straps to the body rail. Do not tighten the straps. Ensure each straps are in place.
8. Tighten the straps in place with a socket wrench. Guarantee each straps are tight. The fuel tank is now ready for fuel.
9. Add the fuel to the tank. Add at the very least 1 / 4 of a tank before starting the engine.
10. Cycle the ignition from off to start. Once you reach the start place, flip the key again to off after 5 seconds. It will engage the fuel pump to fill the lines with fuel.
11. Start the automotive and inspect the gas system for leaks.
12. Lower the vehicle and unchock the wheel.